194000504 - 3340B52 RIGID PIPE (ONE) FROM MASTER CYLINDER (PUMP) TO A.B.S HYDRAULIC CONTROL UNIT - R.R.

Removing ( Refitting ) - Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

1. Disconnect the electrical connection from the brake fluid minimum level warning light switch.

	Description	Connector
1	Brake fluid level sensor (switch)	See K025 BRAKE FLUID LEVEL SENSOR (SWITCH)

2. Undo the connector (2a) and disconnect the rigid pipe from the master cylinder to the A.B.S.hydraulic control unit (2b), master cylinder side.

Collect the bake fluid that comes out in a suitable container.

1. Undo the connector (1a) and disconnect the rigid pipe from the master cylinder to the A.B.S.hydraulic control unit (1b), hydraulic cylinder side and remove it. Refitting ( Removing ) 1. Place the rigid pipe from the master cylinder to the A.B.S. hydraulic control unit (1a) in its housing, connect to the hydraulic control unit and tighten the connector (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

1. Connect the rigid pipe from the master cylinder to the A.B.S. hydraulic control unit (1a), master cylinder side and tighten the connector (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

2. Connect the electrical connection to the brake fluid minimum level warning light switch. - Connect the negative battery terminal.    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY    Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR