3340B62 RIGID PIPE (ONE), LEFT OR RIGHT, FROM HYDRAULIC CONTROL UNIT WITH PIPE CONNECTOR TO REAR BRAKES - R.R. - Fiat - CROMA - eLearn

194000507 - 3340B62 RIGID PIPE (ONE), LEFT OR RIGHT, FROM HYDRAULIC CONTROL UNIT WITH PIPE CONNECTOR TO REAR BRAKES - R.R.

) - Position the vehicle on a lift. Op. 5530B10 BATTERY - R+R Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R. Op. 4450B04 RIGHT FRONT WHEEL - R.R Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R. - Release the rigid pipe from the hydraulic control unit to the rear brake pipe connector from the fastenings in the engine compartment. - Position a hydraulic jack under the front suspension frame.1. Undo the bolts (1a) and remove the underbody reinforcement (1b).

1. Undo the connector (1a), disconnect the rigid pipe from the hydraulic control unit to the rear brke pipe connector (1b) and release it from the underbody fastenings.

- Working in the engine compartment, remove the rigid pipe from the hydraulic control unit to the rear brake pipe connector.

Refitting ( Removing

) - Place the rigid pipe from the hydraulic control unit to the rear brake pipe connector in position.1. Connect the rigid pipe from the hydraulic control unit to the rear brake pipe connector (1a), secure it using the underbody fastenings and tighten the connector (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

1. Place the underbody reinforcement (1a) in its housing and secure it tightening the new bolts (1b) and (1c) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Underbody reinforcements	Inner bolt (to replace)	M12	(bodyshell side) 8.1 - 9.9 + 45°

Component	Fastening	dia	Value (daNm)	Validity
Underbody reinforcements	Outer bolt (to replace)	M10	(bodyshell side) 5.0 - 6.1 + 45°

Component	Fastening	dia	Value (daNm)	Validity
Underbody reinforcements	Bolt (to be replaced)	M12	(front suspension frame side) 9.0 - 11.0 + 90°

- Remove the hydraulic jack from underneath the front suspension frame.

- Secure the rigid pipe from the hydraulic control unit to the rear brake pipe connector to the fastenings in the engine compartment. Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R. Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 4450B04 RIGHT FRONT WHEEL - R.R Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R. Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 5530B10 BATTERY - R+R- Remove the vehicle from the lift.