3340B67 RIGID PIPE FROM RIGHT REAR BRAKE CONNECTOR - R.R. - Fiat - CROMA - eLearn

194000508 - 3340B67 RIGID PIPE FROM RIGHT REAR BRAKE CONNECTOR - R.R.

) - Position the vehicle on a lift. Op. 4450B06 LEFT REAR WHEEL - R.R Op. 7055B44 LEFT REAR WHEEL ARCH LINER - R.R- Remove the protective cap from the bleed valve on the brake caliper.- Connect the recovery device (pipe and reservoir) to the brake caliper bleed valve.- Loosen the bleed valve on the brake caliper and wait until the brake-clutch reservoir and pipes drains.1. Working underneath the vehicle, undo the bolts (1a) and remove the front pipe protection (1b).

1. Undo the bolts and remove the rear pipe protection.2. Undo the bolts (2a) and remove the bracket (2b).

1. Undo the bolts (1a) and (1b), then remove the right underbody reinforcement (1c).

1. Undo the connector (1a) and disconnect the rigid pipe from the connector to the right rear brake (2b), rigid pipe side.

1. Release the rigid pipe from the connector to the right rear brake (1a) from the underbody fastenings (1b).

1. Undo the connector (1a), disconnect the rigid pipe from the connector to the right rear brake (1b), flexible pipe side and remove it after having released it from the fastenings (1c).

Refitting ( Removing

) - Place the rigid pipe from the connector to the right rear brake back in its housing and secure it using the underbody bands.- Connect the rigid pipe from the connector to the right rear brake, flexible pipe side and tighten the connector to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

- Connect the rigid pipe from the connector to the right rear brake, rigid pipe side and tighten the connector to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

1. Place the underbody reinforcement (1a) in its housing and secure it tightening the new bolts (1b) and (1c) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Underbody reinforcements	Inner bolt (to replace)	M12	(bodyshell side) 8.1 - 9.9 + 45°

Component	Fastening	dia	Value (daNm)	Validity
Underbody reinforcements	Outer bolt (to replace)	M10	(bodyshell side) 5.0 - 6.1 + 45°

Component	Fastening	dia	Value (daNm)	Validity
Underbody reinforcements	Bolt (to be replaced)	M12	(front suspension frame side) 9.0 - 11.0 + 90°

- Fit the bracket in its housing and secure it using the bolts.- Place the rear pipe guard in its housing and secure it using the bolts.- Place the front pipe guard in its housing and secure it using the bolts. Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR Op. 7055B44 LEFT REAR WHEEL ARCH LINER - R.R Op. 4450B06 LEFT REAR WHEEL - R.R- Remove the vehicle from the lift.