4130B25 POWER STEERING PUMP ASSEMBLY R R FOR VERSIONS WITH AIR CONDITIONER - Fiat - CROMA - eLearn

194000532 - 4130B25 POWER STEERING PUMP ASSEMBLY R R FOR VERSIONS WITH AIR CONDITIONER

)

The electrohydraulic power assisted steering control unit is incorporated in the power assisted steering pump assembly and cannot be dismantled.

- Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R Op. 1008C34 BRACKET ON GEARBOX FOR LOWER REACTION ROD - R.R.1. Undo the cap and draw off the power assisted steering fluid from the reservoir using a suitable syringe.

1. Disconnect the electrical connections from the power steering pump.

	Description	Connector
1	Electric steering control unit	See M086 CONTROL UNIT

The version with ABS is shown in the diagram. The version with ESP comes with the two electrical connections indicated plus a third electrical connection with wiring for connection to the steering angle sensor.

2. Undo the nuts fixing the power assisted steering pump to the mounting.

1. Undo the bolt (1a) and disconnect the oil delivery and return pipes (1b) from the power assisted steering box.

Collect the power assisted steering fluid that comes out in a suitable container.

2. Undo the bolts fixing the power assisted steering pump mounting to the power steering box.3. Move the power assisted steering pump mounting to the side.4. Remove the power assisted steering pump complete with pipes.- Keep the power assisted steering pump mounting.

1. Working at the bench, loosen the band, disconnect and remove the return pipe from the power assisted steering box to the power assisted steering fluid reservoir.2. Undo the connector (2a) then disconnect and remove the supply pipe (2b) from the pump to the power assisted steering box.

Refitting ( Removing

) - Place the supply pipe from the pump to the power assisted steering box back in its housing and tighten the connector to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Supply pipe from pump to power assisted steering box	Connector	M16x1.5	(electric pump side) 3.0

- Place the return pipe from the power assisted steering box to the fluid reservoir back in its housing and tighten the band.- Place the power assisted steering pump complete with pipes and mounting back in its housing.- Tighten the bolts fixing the power assisted steering pump mounting to the power steering box.- Connect the supply and return pipes to the power assisted steering box and secure them tightening the bolt to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Inlet/outlet pipes on power assisted steering box	Bolt	M8	(power assisted steering box side) 1.0 - 1.2

- Tighten the nuts fixing the power assisted steering pump to the mounting.- Connect the electrical connections to the power steering pump. Op. 1008C34 BRACKET ON GEARBOX FOR LOWER REACTION ROD - R.R. Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.- Connect the negative battery terminal. Op. 0010T71 POWER STEERING FLUID CHECK LEVEL AND TOP UP IF NECESSARY Op. 0010T75 HYDRAULIC POWER STEERING SYSTEM BLEED AIR- Remove the vehicle from the lift.