194000559 - 4420C12 REAR SUSPENSION STABILIZER BAR JOINT - R+R ON VEHICLE

Removing ( Refitting )

In the following procedure the removing-refitting of the left rear suspension anti-roll bar joint is described, carry out the same operations for the right rear suspension anti-roll bar joint.

- Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 4450B06 LEFT REAR WHEEL - R.R1. Disconnect the electrical connection from the left rear wheel rpm sensor.

	Description	Connector
1	Left rear wheel sensor for ABS	See K075 LEFT REAR WHEEL SENSOR FOR ABS

2. Undo the bolt (2a) and remove the left rear suspension anti-roll bar joint (2b). Refitting ( Removing ) 1. Place the left rear suspension anti-roll bar joint (1a) in its housing and secure it by tightening the new bolt (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Rear suspension anti-roll bar joint	Bolt (to be replaced)	M10	(steering knuckle side) 4.1 - 5.0 + 60°

2. Connect the electrical connection to the left rear wheel rpm sensor.     Op. 4450B06 LEFT REAR WHEEL - R.R- Connect the negative battery terminal.- Remove the vehicle from the lift.