194000762 - 5550A10 STALK UNIT ASSEMBLY - R+R
 | Before working on the air bag system, it is essential to perform the following preliminary operations. |
- Turn the ignition key to the OFF position and extract it.- Disconnect the battery leads and insulate them.- Wait for 10 minutes before continuing.
Removing
(
Refitting
)
Op. 5580C18 AIR BAG MODULE - R+R Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS Op. 7040A26 STEERING COLUMN TRIM - R+R1. Disconnect the electrical connection for clock spring.2. Working from below, loosen the bolt of anchorage collar (2a) and withdraw stalk unit (2b) from the steering column.
1. Release the anchorages and disconnect connections (1a) and (1b). | Description | Connector |
|---|
| 1a | ABS COUPLING | See D005 ABS COUPLING |
| Description | Connector |
|---|
| 1b | ABS COUPLING | See D005 ABS COUPLING |
| Description | Connector |
|---|
| 1b | ABS COUPLING | See D005 ABS COUPLING |
- Turn the stalk unit through 180°.1. Disconnect the electrical connection of the Cruise Control device on the rear of the stalk unit, release wiring harness (1c) from anchorages (1b) and remove the stalk unit (1d).
Refitting
(
Removing
)
 | Parts supplies new stalk units complete with steering angle sensor. The steering angle sensor electrical connector must be secured so that it does not cause noise while the vehicle is in motion. |
- Connect the electrical connections to the stalk unit complete with clock spring. | Description | Connector |
|---|
| ABS COUPLING | See D005 ABS COUPLING |
- Engage the wiring harness in the anchorages- Position the stalk unit complete with clock spring on the steering column. Op. 7040A26 STEERING COLUMN TRIM - R+R | Before fitting the steering wheel in its seat, split the red key on the stalk unit that ensures its protection. |
Op. 5580C18 AIR BAG MODULE - R+R- Connect the battery terminals.
