194000800 - 5580C10 DECELERATION SENSOR FOR AIR BAG (ONE), L/H OR R/H - R+R

Refitting ( Removing )

Before removing and refitting the control unit the following preliminary operations must be carried out.

- Turn the ignition key to the OFF position and extract it.- Disconnect the negative and positive battery terminals and insulate them.- Wait for 10 minutes before continuing.

	Description	Connector
	BATTERY	See A001 BATTERY

FOLLOW ALL THE RECOMMENDED SAFETY INSTRUCTIONS    Op. 5580C AIR BAG SYSTEM

Removing ( Refitting ) 1. Working on the engine compartment upper crossmember, unscrew bolt (1a) and release reference pin (1b). Remove the deceleration sensor from its seat. 1. Disconnect the electrical connection (1a) and remove the deceleration sensor for Air Bag sensor (1b) from the vehicle.

	Description	Connector
1a	SENSOR FOR DRIVER''S SIDE FRONT BAG	See K175 DRIVER'S SIDE FRONT AIR BAG SENSOR

	Description	Connector
1a	SENSOR FOR PASSENGER SIDE FRONT AIR BAG	See K176 PASSENGER SIDE FRONT AIR BAG SENSOR

Refitting ( Removing ) - Check that the Air Bag deceleration sensor is not damaged.- Connect the electrical connection to the Air Bag deceleration sensor.

	Description	Connector
	SENSOR FOR DRIVER''S SIDE FRONT BAG	See K175 DRIVER'S SIDE FRONT AIR BAG SENSOR

	Description	Connector
	SENSOR FOR PASSENGER SIDE FRONT AIR BAG	See K176 PASSENGER SIDE FRONT AIR BAG SENSOR

- Position the deceleration sensor for the Air Bag correctly in its housing, attaching the reference pin, screw in the fixing bolt and tighten it to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
FRONT IMPACT SENSOR TO HEADLAMP HOLDER CROSSMEMBER	Bolt	M6	0,64 ÷ 0,96

- Connect the negative and positive battery terminals.

	Description	Connector
	BATTERY	See A001 BATTERY

- Check the operation of the system using the Examiner.