194001120 - 7045J80 FRONT SEAT MOVEMENT SYSTEM WIRING BUNDLE - R R OR REPLACE

Removing ( Refitting ) - Open the front side door.- Turn the ignition key to the OFF position.- Disconnect the negative battery terminal.
DescriptionConnector
BATTERY    See A001 BATTERY
    Op. 7045A10 FRONT SEAT (ONE), LEFT OR RIGHT - R.R.1. Undo the bolts (1a) and (1b).2. Release the guard (2a) from the front mounting (2b) and remove it releasing it from the rear section.
1. Disconnect the electrical connections (1a) and (1b) for the control unit.
DescriptionConnector
1aDRIVING POSITION NODE    See M173 DRIVE ALIGNMENT NODE
DescriptionConnector
1bDRIVING POSITION NODE    See M173 DRIVE ALIGNMENT NODE
DescriptionConnector
1aPASSENGER POSITION NODE    See M175 PASSENGER ALIGNMENT NODE
DescriptionConnector
1bPASSENGER POSITION NODE    See M175 PASSENGER ALIGNMENT NODE
2. Disconnect the electrical connection for the heater pad switch (2a) and remove the guard complete with control unit and switch (2b).
DescriptionConnector
2aDRIVER''S SEAT HEATER SWITCH    See I065 DRIVER'S SEAT HEATING SWITCH
DescriptionConnector
2aPASSENGER SEAT HEATER SWITCH    See I066 PASSENGER SEAT HEATING SWITCH
3. Disconnect the electrical connection for the backrest adjustment motor.
DescriptionConnector
3DRIVER''S SEAT BACKREST ADJUSTMENT MOTOR    See N132 DRIVER'S SEAT BACKREST ADJUSTMENT MOTOR
DescriptionConnector
3PASSENGER SEAT BACKREST ADJUSTMENT MOTOR    See N135 PASSENGER SEAT BACKREST ADJUSTMENT MOTOR
1. Disconnect the electrical connection for the motor for sliding (1a), the motor for lifting (1b) and the motor for rocker adjustment (1c).
DescriptionConnector
1aDRIVER''S SEAT SLIDING ADJUSTMENT MOTOR    See N127 DRIVER'S SEAT SLIDING ADJUSTMENT MOTOR
DescriptionConnector
1aPASSENGER SEAT SLIDING ADJUSTMENT MOTOR    See N130 PASSENGER SIDE SEAT SLIDE ADJUSTMENT MOTOR
DescriptionConnector
1bLEFT FRONT SEAT REAR HEIGHT ADJUSTMENT MOTOR    See N125 LEFT FRONT SEAT REAR HEIGHT ADJUSTMENT MOTOR
DescriptionConnector
1bPASSENGER SIDE SEAT RAISING MOTOR    See N128 PASSENGER SEAT LIFT MOTOR
DescriptionConnector
1cLEFT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR    See N126 LEFT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR
DescriptionConnector
1cRIGHT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR    See N129 RIGHT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR
Before starting to detach the cable loom, it is advisable to mark the route and the mounting points to facilitate the refitting later on.
2. Cut the retaining bands (2a), using the special tool release the retaining buttons (2b) and release the wiring (2c) from the seat.
ToolDescriptionFunctionValidity
1878077000KnifeRetainer removal
1. Cut the retaining band (1a), lift up the locking tab (1b) and release the cover (1c).
1. Pressing on the side shown by the arrow, release the electrical connection (1a) and release it from the coupling (1b) marking the position.
DescriptionConnector
1aDRIVER''S FRONT SEAT BELT PRETENSIONER    See Q020 DRIVER'S SIDE FRONT BELT PRETENSIONER
DescriptionConnector
1aPASSENGER FRONT SEAT BELT PRETENSIONER    See Q021 PASSENGER SIDE FRONT BELT PRETENSIONER
1. Release the retainers and lift up the backrest cover (1a) and release the cushion cover (1b) from the seat frame.2. Disconnect the electrical connection for the cushion heater pad (2a) and the electrical connection for the electronic thermostat (2b).
DescriptionConnector
2aHEATER PAD WITH LEFT FRONT SEAT SENSOR    See O046 LEFT FRONT SEAT HEATER PAD WITH SENSOR
DescriptionConnector
2aHEATER PAD WITH RIGHT FRONT SEAT SENSOR    See O047 RIGHT FRONT SEAT HEATER PAD WITH SENSOR
DescriptionConnector
2bDRIVER''S FRONT SEAT HEATER CONTROL UNIT    See M170 DRIVE SIDE FRONT PASSENGER SEAT HEATER CONTROL UNIT
DescriptionConnector
2bPASSENGER FRONT SEAT HEATER CONTROL UNIT    See M110 FRONT PASSENGER SEAT HEATER CONTROL UNIT
1. Lift up the hinges (1a) and move the side of the backrest (1b).2. Disconnect the electrical connection for the backrest heater pad.
DescriptionConnector
2LEFT FRONT BACKREST HEATER PAD    See O048 LEFT FRONT BACKREST HEATER PAD
DescriptionConnector
2RIGHT FRONT BACKREST HEATER PAD    See O049 RIGHT FRONT BACKREST HEATER PAD
3. Disconnect the electrical connection (3a) and the earth lead (3b) for the side bag module.
DescriptionConnector
3aDRIVER''S SIDE BAG    See Q030 DRIVER'S SIDEBAG
DescriptionConnector
3aPASSENGER SIDE BAG    See Q031 PASSENGER SIDEBAG
4. Remove the cable loom, releasing it carefully from the seat frame.
Refitting ( Removing ) - Check the condition of the cable loom and place it on the seat as marked previously.- Connect the electrical connection and the earth lead for the side bag module.
DescriptionConnector
DRIVER''S SIDE BAG    See Q030 DRIVER'S SIDEBAG
DescriptionConnector
PASSENGER SIDE BAG    See Q031 PASSENGER SIDEBAG
- Connect the electrical connection for the backrest heater pad.
DescriptionConnector
LEFT FRONT BACKREST HEATER PAD    See O048 LEFT FRONT BACKREST HEATER PAD
DescriptionConnector
RIGHT FRONT BACKREST HEATER PAD    See O049 RIGHT FRONT BACKREST HEATER PAD
- Position the upholstery and the backrest cover, then close the hinges.- Connect the electrical connection for the cushion heater pad and the electrical connection for the electronic thermostat.
DescriptionConnector
HEATER PAD WITH LEFT FRONT SEAT SENSOR    See O046 LEFT FRONT SEAT HEATER PAD WITH SENSOR
DescriptionConnector
HEATER PAD WITH RIGHT FRONT SEAT SENSOR    See O047 RIGHT FRONT SEAT HEATER PAD WITH SENSOR
DescriptionConnector
DRIVER''S FRONT SEAT HEATER CONTROL UNIT    See M170 DRIVE SIDE FRONT PASSENGER SEAT HEATER CONTROL UNIT
DescriptionConnector
PASSENGER FRONT SEAT HEATER CONTROL UNIT    See M110 FRONT PASSENGER SEAT HEATER CONTROL UNIT
- Fit the cover for the cushion to the frame and attach the retainers for the backrest cover.- Fit the retaining buttons for the cable loom at the points marked previously and fit new retaining bands.- Connect the electrical connection for the motor for sliding, the motor for lifting and the motor for rocker adjustment.
DescriptionConnector
DRIVER''S SEAT SLIDING ADJUSTMENT MOTOR    See N127 DRIVER'S SEAT SLIDING ADJUSTMENT MOTOR
DescriptionConnector
PASSENGER SEAT SLIDING ADJUSTMENT MOTOR    See N130 PASSENGER SIDE SEAT SLIDE ADJUSTMENT MOTOR
DescriptionConnector
LEFT FRONT SEAT REAR HEIGHT ADJUSTMENT MOTOR    See N125 LEFT FRONT SEAT REAR HEIGHT ADJUSTMENT MOTOR
DescriptionConnector
PASSENGER SIDE SEAT RAISING MOTOR    See N128 PASSENGER SEAT LIFT MOTOR
DescriptionConnector
LEFT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR    See N126 LEFT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR
DescriptionConnector
RIGHT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR    See N129 RIGHT FRONT SEAT FRONT HEIGHT ADJUSTMENT MOTOR
- Fit the electrical connection on the couplig in the position marked previously.
DescriptionConnector
DRIVER''S FRONT SEAT BELT PRETENSIONER    See Q020 DRIVER'S SIDE FRONT BELT PRETENSIONER
DescriptionConnector
PASSENGER FRONT SEAT BELT PRETENSIONER    See Q021 PASSENGER SIDE FRONT BELT PRETENSIONER
- Fit the cover for the coupling and fit a new retaining band.- Connect the electrical connections for the control unit.
DescriptionConnector
DRIVING POSITION NODE    See M173 DRIVE ALIGNMENT NODE
DescriptionConnector
PASSENGER POSITION NODE    See M175 PASSENGER ALIGNMENT NODE
- Connect the electrical connection for the heater pad switch.
DescriptionConnector
DRIVER''S SEAT HEATER SWITCH    See I065 DRIVER'S SEAT HEATING SWITCH
DescriptionConnector
PASSENGER SEAT HEATER SWITCH    See I066 PASSENGER SEAT HEATING SWITCH
- Connect the electrical connection for the backrest adjustment motor.
DescriptionConnector
DRIVER''S SEAT BACKREST ADJUSTMENT MOTOR    See N132 DRIVER'S SEAT BACKREST ADJUSTMENT MOTOR
DescriptionConnector
PASSENGER SEAT BACKREST ADJUSTMENT MOTOR    See N135 PASSENGER SEAT BACKREST ADJUSTMENT MOTOR
- Fit the outer guard in the rear section, attach it to the front mounting and tighten the fixing bolts.    Op. 7045A10 FRONT SEAT (ONE), LEFT OR RIGHT - R.R.- Connect the negative battery terminal.
DescriptionConnector
BATTERY    See A001 BATTERY