194001229 - 7210B51 R R UPPER CHANNEL STIFFENER, (ONE) LH OR RH

Removing ( Refitting )     Op. 7210E52 R.R. REAR WING    Op. 7210B75 R.R. REAR LIGHT CLUSTER HOUSING    Op. 7210E34 R.R. ROOF PANEL/SIDE PANEL CONNECTION PROFILE-MOULDING    Op. 7210E28 R.R. ROOF PANEL- Check that the components connected are not distorted by checking the bodyshell alignment measurements using suitable equipment (gauges, templates or jigs).- Straighten the body as necessary. 1. Use the drill and chamfer the spot welds in the areas shown in the diagram.2. Use the chamfering machine and chamfer the spot welds along the perimeter of the pillar.- Use the hammer and chisel and remove the spot welds chamfered previously.3. Remove the reinforcement. - Straighten the edges of the vehicle using a hammer and dolly block.- Remove the spot weld residues using a disc grinder.- Use a rotary brush to clean the areas treated previously.1. Apply electro-galvanizing paint. - Work at the bench and remove the anti-corrosion treatment from the entire perimeter of the inner and outer parts using the rotary brush.1. Use the drill to make openings at the points shown.- Apply electro-weldable paint to the edges treated previously. Refitting ( Removing ) 1. Position the reinforcement correctly on the vehicle placing the top edges as illustrated in the diagram and fasten with self-locking clamps.2. Use a spot welder in the areas shown.3. Use a MIG welder and weld the openings made previously in the replacement part. - Correct any distortions to the panel using a hammer and dolly block.1. Use a disc grinder to level and remove the welding.- Use a rotary brush to clean the areas welded previously.- Apply anti-oxidant protection to the areas involved in the welding.- Proceed with the painting stage.     Op. 7210E28 R.R. ROOF PANEL    Op. 7210E34 R.R. ROOF PANEL/SIDE PANEL CONNECTION PROFILE-MOULDING    Op. 7210B75 R.R. REAR LIGHT CLUSTER HOUSING    Op. 7210E52 R.R. REAR WING