194000894 - 7010A14 REAR SIDE DOOR - ADJUST CENTERING AND MOULDING - INCLUDES ADAPTATION OF HINGES AND SEALS ON DOOR COMPARTMENT

- Carry out the operations described below to adjust the door in a vertical and lengthwise direction.    Op. 7040L44 REAR DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R.    Op. 7040H36 CENTRE PILLAR LOWER ELEMENT (ONE), LEFT OR RIGHT - R.R1. If the adjustment is carried out after having removed the door, tighten the hinge bolts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
FRONT AND REAR DOOR MOVING HINGES	Bolt	M6	1,2÷ 1,8

2. Undo the bolts (2a) fixing the check strap (2b) and make sure it is in the correct position when the door is closed again.3. Loosen the bolts fixing the hinges to the bodyshell on both the outside and the inside (detail A).4. Adjust the position of the door, in the directions shown by the arrows using the slotted openings in the bolts so that it is perfectly aligned with the bodywork.

It is advisable to work on the hinges, one at a time. The arrows indicate the possible movements for the adjustment.

- When the adjustment is completed, tighten the door hinge bolts, bodyshell side, to torque.

Component	Fastening	dia	Value (daNm)	Validity
REAR DOOR UPPER HINGES ON HINGE ATTACHMENT REINFORCEMENT (BODYSHELL)	Bolt	M8	2,88 ÷ 3,52

Component	Fastening	dia	Value (daNm)	Validity
REAR DOOR LOWER HINGES ON HINGE ATTACHMENT REINFORCEMENT (BODYSHELL)	Bolt	M8	2,88 ÷ 3,52

- Carry out the operations described below for the transverse adjustment of the door in relation to the door housing seal.1. Loosen the bolts (1a) fixing the door striker (1b). 1. Loosen the bolts, door side, fixing the door hinges.2. Adjust the position of the door, in the directions shown by the arrows using the slotted openings in the bolts so that it is perfectly aligned with the bodywork.

It is advisable to work on the hinges, one at a time. The arrows indicate the possible movements for the adjustment.

- When the adjustment is completed, tighten the door hinge bolts, door side, to torque.

Component	Fastening	dia	Value (daNm)	Validity
UPPER HINGES ON REAR DOOR ASSEMBLY	Bolt	M8	2,88 ÷ 3,52

Component	Fastening	dia	Value (daNm)	Validity
FRONT AND REAR DOOR STRIKER WITH OUTER PANEL AND INTERMEDIATE PILLAR REINFORCEMENT	Bolt	M8	2,88 ÷ 3,52

- Adjust the door striker and tighten the fixing bolts to torque.

Component	Fastening	dia	Value (daNm)	Validity
FRONT AND REAR DOOR STRIKER WITH OUTER PANEL AND INTERMEDIATE PILLAR REINFORCEMENT	Bolt	M8	2,88 ÷ 3,52

1. Take out the door check strap (1a) and tighten the fixing bolts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
FRONT AND REAR DOOR STRIKER WITH OUTER PANEL AND INTERMEDIATE PILLAR REINFORCEMENT	Bolt	M8	2,88 ÷ 3,52

    Op. 7040H36 CENTRE PILLAR LOWER ELEMENT (ONE), LEFT OR RIGHT - R.R    Op. 7040L44 REAR DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R.