3330D03 SERVO BRAKE / BRAKE PUMP ASSEMBLY - R.R. FOR RIGHT DRIVE VERSIONS - Fiat - CROMA - eLearn

194004022 - 3330D03 SERVO BRAKE / BRAKE PUMP ASSEMBLY - R.R. FOR RIGHT DRIVE VERSIONS

) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).1. Undo the bolts (1a) and remove the guard under the dashboard (1b).2. Remove the retaining clip (2a), release the return spring (2b) and extract the pin (2c) connecting the brake servo to the brake pedal.

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. Op. 3330C12 MASTER CYLINDER (PUMP) - R.R. FOR RIGHT HAND DRIVE VERSIONS Op. 1048A10 AIR FILTER ASSEMBLY - R.R. Op. 1016A10 SOUND-PROOFING COVER - R.R Op. 1048A50 TURBOCHARGER AIR INTAKE PIPE - R.R. Op. 1084A16 OIL DIPSTICK PIPE - R.ROp. 1048A28 VACUUM AIR CIRCUIT RESONATOR PIPE - R+R Op. 4450B04 RIGHT FRONT WHEEL - R.R Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R. Op. 1092G10 SINGLE ENGINE BELT - R.R Op. 1092A10 CRANKSHAFT PULLEY - R + R Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT Op. 1060E10 DIESEL INJECTION PRESSURE PUMP - R.R. Op. 1060E40 PRESSURE PUMP SUPPORT - R.R.1. Disconnect the vacuum pipe from the brake servo.2. Undo the bolts (2a) and remove the brake servo (2b).

Refitting ( Removing

) - Clean the surface of the brake servo and the engine compartment bulkhead.1. Place the brake servo (1a) in its housing and fasten it tightening the bolts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake servo	Bolt	M8	(pedals side) 1.8 - 2.2

2. Connect the vacuum pipe to the brake servo.

Op. 1060E40 PRESSURE PUMP SUPPORT - R.R. Op. 1060E10 DIESEL INJECTION PRESSURE PUMP - R.R. Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT Op. 1092A10 CRANKSHAFT PULLEY - R + R Op. 1092G10 SINGLE ENGINE BELT - R.R Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R. Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R. Op. 4450B04 RIGHT FRONT WHEEL - R.ROp. 1048A28 VACUUM AIR CIRCUIT RESONATOR PIPE - R+R Op. 1084A16 OIL DIPSTICK PIPE - R.R Op. 1048A50 TURBOCHARGER AIR INTAKE PIPE - R.R. Op. 1016A10 SOUND-PROOFING COVER - R.R Op. 1048A10 AIR FILTER ASSEMBLY - R.R. Op. 3330C12 MASTER CYLINDER (PUMP) - R.R. FOR RIGHT HAND DRIVE VERSIONS Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.- Place the pin connecting the brake servo to the brake pedal in its housing, connect the return spring and fit the retaining clip.- Place the guard under the dashboard back in its housing and secure it using the bolts.- Connect the negative battery terminal. Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR- Remove the vehicle from the lift.