194000384 - 1084A42 ENGINE OIL PRESSURE WARNING LIGHT SWITCH - R + R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.1. Disconnect the electrical connection from the engine oil pressure warning light switch.

	Description	Connector
1	Insufficient engine oil pressure sensor (switch), K030	See K030 INSUFFICIENT ENGINE OIL PRESSURE SENSOR

2. Undo and remove the engine oil pressure warning light switch. Refitting ( Removing ) - Replace the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Switch for engine oil pressure warning light	-	M14	(support side) 2.3 - 2.8	1.9 JTD 16v1.9 JTD 8v2.4 JT 20v

- Connect the electrical connection to the engine oil pressure warning light switch.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.- Connect the negative battery terminal.- Remove the vehicle from the lift.