194003996 - 1084B34 CARTRIDGE ENGINE OIL FILTER SUPPORT - R + R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.    Op. 1084A16 OIL DIPSTICK PIPE - R.R    Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R1. Undo the bolts (1a) and disconnect the engine oil supply and return pipe (1b), engine oil filter mounting side.
Collect the engine oil that comes out in a suitable container.
2. Disconnect the electrical connection from the engine oil pressure warning light switch.
DescriptionConnector
2Insufficient engine oil pressure sensor (switch)    See K030 INSUFFICIENT ENGINE OIL PRESSURE SENSOR
3. Loosen the band and disconnect the oil return pipe to the sump, cartridge engine oil filter mounting side.4. Undo the bolts (4a) and remove the cartridge engine oil filter mounting (4b).
Refitting ( Removing ) - Place the cartridge engine oil filter mounting in its housing and secure it tightening the bolts to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Engine oil filter mountingBolt-52.4 JTD 20v
- Connect the oil return pipe to the sump, cartridge engine oil filter mounting side and tighten the band.- Connect the electrical connection to the engine oil pressure warning light switch.- Connect the engine oil supply and return pipes, engine oil filter mounting side and secure them using the bolts.    Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R    Op. 1084A16 OIL DIPSTICK PIPE - R.R- Connect the negative battery terminal.    Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP, IF NECESSARY    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.- Remove the vehicle from the lift.