194001161 - 7050D35 LEFT REAR SEAT BACKREST COVER (TWO SEATER) - R.R. WITH BACKREST REMOVED

Removing ( Refitting )     Op. 7050A31 MOUNT (ONE) FITTING REAR SEAT TO FLOOR - R R    Op. 7050A40 CENTRAL REAR SEAT BELT PANNEL ATTACHMENT R R    Op. 7050B30 REAR SEAT CENTRE ARMREST - R.R.    Op. 7050B10 ERAR SEAT HEAD RESTRAINT (ONE), LEFT OR RIGHT - R.R.    Op. 7050B08 GUIDE BUSH FOR HEAD RESTRAINT (ONE) FOR REAR SEAT - R.R1. Undo the fixing bolts (1a) and remove the side panel (1b).
1. Prise up and remove the zip fastening retaining clamps.2. Open the zip by applying pressure on edges (2a) in the direction shown in the figure or by means of the cursor (2b).
1. Raise the padding of backrest (1a) and at the rear, prise up the profile (1b) retaining the backrest frame trim (1c).- Cut the retaining rings between the cover and the padding using clippers and remove the trim.
Refitting ( Removing )
To remove the seat belt from the reel, arrange the seat backrest in the position in which it is fitted in the vehicle.
- Arrange the backrest trim and use an appropriate tool to crimp the retaining rings between trim and padding.
ToolDescriptionFunctionValidity
1878017001Pliers for metal pointsFitting new backrest cover retaining rings
- Fit the retaining profile and ensure the seat belt is outside the seat padding through the holes in the trim.    Op. 7050A40 CENTRAL REAR SEAT BELT PANNEL ATTACHMENT R R1. Re-check the arrangement of the trim and use the cursor provided (1a) to close the zips. To prevent the zips from opening, use new retaining clamps (1c) to be fitted on the ends of the zips.
- After closure, remove the cursor of the closed zip and carry out the same operation to close all the zips.    Op. 7050B08 GUIDE BUSH FOR HEAD RESTRAINT (ONE) FOR REAR SEAT - R.R    Op. 7050B10 ERAR SEAT HEAD RESTRAINT (ONE), LEFT OR RIGHT - R.R.    Op. 7050B30 REAR SEAT CENTRE ARMREST - R.R.    Op. 7050A31 MOUNT (ONE) FITTING REAR SEAT TO FLOOR - R R