194000947 - 7015A58 INTERNAL TAILGATE MOULDING (ONE) - R+R

Removing ( Refitting ) - Open the tailgate.- Turn the ignition key to the OFF position.- Disconnect the negative battery terminal.
DescriptionConnector
BATTERY    See A001 BATTERY
1. Use a cutter to cut the anchorage points (1a) shown in the figure. Prise up moulding (1b) and turn down, taking care not to damage the wiring connected to the third brake light.
ToolDescriptionFunctionValidity
1878077000KnifeRetainer removal
1. Disconnect the electrical connection (1a) and remove the moulding (1b) from the tailgate.
DescriptionConnector
1aADDITIONAL REAR LIGHT (THIRD BRAKE LIGHT)    See F040 ADDITIONAL REAR LIGHT (THIRD BRAKE LIGHT)
Refitting ( Removing ) - Connect the electrical connection to the third brake light.
DescriptionConnector
ADDITIONAL REAR LIGHT (THIRD BRAKE LIGHT)    See F040 ADDITIONAL REAR LIGHT (THIRD BRAKE LIGHT)
- Place the moulding correctly in position in its housing and press on the mounting points to fit the clips.- Reconnect the negative battery terminal.
DescriptionConnector
BATTERY    See A001 BATTERY