1056B60 SINGLE FUEL MANIFOLD PIPE, WITH INJECTORS - R.R. - Fiat - CROMA - eLearn

194000318 - 1056B60 SINGLE FUEL MANIFOLD PIPE, WITH INJECTORS - R.R.

) 1. Undo the plug and fit the connector to discharge the fuel pressure.

Tool	Description	Function	Validity
2000002900	Breather connector	Fuel system pressure drainage	1.82.2

- Use a suitable container for collecting the fuel.

1. Disconnect the rapid connector for the front fuel pipe, manifold pipe side.2. Disconnect the electrical connection for the fuel vapour solenoid valve.

	Description	Connector
2	Fuel vapour recovery solenoid valve	See L010 FUEL VAPOUR RECOVERY SOLENOID VALVE

3. Connect the electrical connection for the injection control unit.

	Description	Connector
3	Engine management control unit	See M010 ENGINE MANAGEMENT CONTROL UNIT

4. Remove the wiring duct from the retaining clips.5. Disconnect the electrical connections for the injectors.

	Description	Connector
5	Injector	See N070 INJECTOR

6. Undo the fixing bolts and remove the fuel manifold pipe complete with injectors.

1. Release the retaining clip (1a) and remove the injector (1b) from the manifold pipe.- Remove the remaining injectors in the same way.

Refitting ( Removing

) - Fit a new O-ring on the top of each injector that has been removed.- Place the injectors back in their seats and secure them using the clips.- Fit the fuel pipe complete with injectors and tighten the bolts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Single fuel manifold pipe	Bolt	M6	0.8 ÷ 1.0	1.8

- Connect the electrical connections for the injectors.- Refit the wiring duct and secure it using the retaining clips.- Connect the electrical connection for the injection control unit.- Connect the electrical connection for the fuel vapour solenoid valve.- Connect the rapid connector for the front fuel pipe, manifold pipe side.