2710A10 DRIVESHAFT WITH JOINTS (ONE), L/H OR R/H - R + R - Fiat - CROMA - eLearn

194000462 - 2710A10 DRIVESHAFT WITH JOINTS (ONE), L/H OR R/H - R + R

)

The following procedure describes removal/refitting of the right drive shaft, do the same for the left drive shaft.

- Position the vehicle on a lift. Op. 4450B04 RIGHT FRONT WHEEL - R.R1. Remove front hub cap (1a) using the tool (1b).

Tool	Description	Function	Validity
1847014000	Extractor	Removing front hub cap

1. Undo the nut (1a) securing the right front driveshaft to the wheel hub using tool (1b) for counter-torque.

Tool	Description	Function	Validity
1870815000	Counter-torque	Loosen/tighten nut securing front driveshaft to wheel hub

2. Undo the nut fixing the steering rod to the right front steering knuckle.

1. Disconnect the steering link (1a) from the right front steering knuckle using the tool (1b).

Tool	Description	Function	Validity
1871000700	Extractor	Extracting steering rod from steering knuckle

1. Unscrew the bolt (1a) and disconnect the lower wishbone (1b) from the right front steering knuckle.

Do not use expansion tools to disconnect the lower wishbone from the front steering knuckle.

1. Use the tool to move the driveshaft back from the wheel hub.

Tool	Description	Function	Validity
2000001600	Extractor	Retract driveshaft from front wheel hub

1. Extract the right driveshaft from the differential and remove it.

Refitting ( Removing

) - Place the driveshaft in its housing on the differential, taking care not to damage the teeth.- Refit the drive shaft in its seat on the wheel hub and secure by screwing in a new nut without tightening.1. Connect lower wishbone (1a) to the right front stub axle and tighten a new bolt (1b) to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Front suspension lower track control arm	Bolt (to be replaced)	M10	(steering knuckle side) 2.7 - 3.3 + 60°

1. Tighten the new nut (1a) securing the right front driveshaft to the wheel hub using the tool (1b) for counter-torque.

Component	Fastening	dia	Value (daNm)	Validity
Front wheel hub	Nut (to replace)	M24	(driveshaft side) see operation 4450C28

Tool	Description	Function	Validity
1870815000	Counter-torque	Loosen/tighten nut securing front driveshaft to wheel hub

- Refit a new front hub cap in its seat using the appropriate tool.2. Connect the steering links (2a) to the right front steering knuckles and tighten the nut (2b) to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Steering rods	Nut	M12	(steering knuckle side) 3.0 - 4.0

Op. 4450B04 RIGHT FRONT WHEEL - R.R- Remove the vehicle from the lift.