194003982 - 7010OA REAR DOORS NOISE LOCALISATION

Tape the various areas illustrated in the diagram using bodywork gummed paper. Carry out a road test letting the vehicle gradually reach the speeds where the noise starts: if the wind noise persists, check for sealant between the wing and the pillar in the lower area.Remove the gummed paper from the area and repeat the road test: if the wind noise persists, adjust the door hinges.    Op. 7010A14 REAR SIDE DOOR - ADJUST CENTERING AND MOULDING - INCLUDES ADAPTATION OF HINGES AND SEALS ON DOOR COMPARTMENTRemove or add shims from/to the two hinges so that the door and the seal fit together better.Remove the gummed paper from the area and repeat the road test: if the wind noise persists, adjust the door hinges.    Op. 7010A14 REAR SIDE DOOR - ADJUST CENTERING AND MOULDING - INCLUDES ADAPTATION OF HINGES AND SEALS ON DOOR COMPARTMENTRemove or add shims from/to the two hinges so that the door and the seal fit together better.Remove the gummed paper from the area and repeat the road test, if the wind noise persists, check the condition of the door housing seal in that area and make sure it adheres to the bodyshell correctly.    Op. 7010A34 REAR SIDE DOOR COMPARTMENT SEAL - R.RAlso check that the window sliding seal is correctly matched (with the window closed).Remove the gummed paper from the area and repeat the road test: if the wind noise persists, check the condition of the glass scraper.    Op. 7010D26 REAR SIDE DESCENDING WINDOW GLASS SCRAPER (OUTER) (ONE), LEFT OR RIGHT - R.R