198003790 - 3330D23 REACTION ROD ON BRAKE SERVO MASTER CYLINDER - R.R. FOR RIGHT HAND DRIVE VERSIONS

Removing ( Refitting )     Op. 7040L37 GEAR LEVER TRIM - R.R     Op. 7040L73 BOTTLE-HOLDER/ASHTRAY ON REAR TUNNEL TRIM - R.R.    Op. 7040L70 TUNNEL COVER REAR TRIM - R.R.    Op. 7040L20 TUNNEL COVER - R.R     Op. 7040A65 CONSOLE SIDE CLOSING (ONE) - R.R.    Op. 7040A14 FLAP FOR GLOVE COMPARTMENT IN DASHBOARD - R.R.    Op. 7040A44 LEFT DASHBOARD SIDE TRIM - R.R.    Op. 7040A18 GLOVE COMPARTMENT IN DASHBOARD - ARRANGE 1. Press the retaining tabs and disconnect the brake servo push rod from the brake pedal. 1. Remove the retaining clip (1a) and release the pin (1b) fastening the forks.2. Undo the bolt (2a) and remove the lever idler (2b). 1. Remove the bushes (1a), the clip (1b) and the spacer (1c). Refitting ( Removing ) - Fit the new bushes, spacer and clip on the lever idler.- Place the lever idler back in its housing and tighten the bolt.- Fit the new brake servo push rod retaining device to the idler lever.- Raise the idler lever so that the brake servo push rod is attached to the retaining device.- Connect the levers to the idler and secure them using the pin and the retaining clip.     Op. 7040A18 GLOVE COMPARTMENT IN DASHBOARD - ARRANGE     Op. 7040A44 LEFT DASHBOARD SIDE TRIM - R.R.    Op. 7040A14 FLAP FOR GLOVE COMPARTMENT IN DASHBOARD - R.R.    Op. 7040A65 CONSOLE SIDE CLOSING (ONE) - R.R.    Op. 7040L20 TUNNEL COVER - R.R     Op. 7040L70 TUNNEL COVER REAR TRIM - R.R.    Op. 7040L73 BOTTLE-HOLDER/ASHTRAY ON REAR TUNNEL TRIM - R.R.    Op. 7040L37 GEAR LEVER TRIM - R.R