198000050 - 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R.

Removing ( Refitting ) - Unscrew the brake-clutch fluid reservoir plug and fit the tool.

Tool	Description	Function	Validity
2000001400	Plug	Brake/ clutch system vacuum

Mark the position of the pipes before unscrewing the connectors.

1. Unscrew the connectors for the pipes from the ABS control unit.2. Disconnect the electrical connection for the A.B.S. control unit.

	Description	Connector
2	ABS control unit	See M050 ABS CONTROL UNIT

3. Undo the nuts (3a) fixing the ABS control unit (3b) to the support and remove it. Refitting ( Removing ) - Fit the ABS control unit in its seat and tighten the nuts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
A.B.S. hydraulic control unit to bracket	Nut	M6	0.7 ÷ 0.9

- Disconnect the electrical connection for the A.B.S. control unit.- Tighten the ABS control unit pipe fittings to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10	1.4 ÷ 1.8

    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR For versions with ESP only:if the hydraulic and electronic control unit is being replaced, connect the Examiner and calibrate the slewing sensor and the steering angle sensor.