198000298 - 3340A20 ABS ELECTRONIC CONTROL UNIT - R+R

Removing ( Refitting )     Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R. 1. Undo the bolts (1a) and remove the ABS electronic control unit (1b) from the hydraulic control unit.

Protect the inner part of the control unit and the two pressure sensor contact terminals.

Refitting ( Removing ) - Refit the ABS system electronic control unit in its housing and secure it tightening the bolts to the recommended torque.

Carefully match the contact terminals for the electric pump and the pressure sensor (where fitted).

Component	Fastening	dia	Value (daNm)	Validity
A.B.S. electronic control unit	Bolt	M4	0.25

    Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R.     Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR For versions with ESP only:if the electronic control unit is being replaced, connect the Examiner and calibrate the slewing sensor and the steering angle sensor.