198000478 - E3080 HEADLIGHT ALIGNMENT ADJUSTMENT - DESCRIPTION
DESCRIPTION
The adjustment of the headlamp light beam according to the load is carried out by means of a special device (located inside the front light cluster) which tilts it appropriately, lowering the light beam if the vehicle is heavily laden and raising it if the load lessens.This adjustment can be carried out by pressing the "+" and "-" buttons in the control unit in the middle of the dashboard, left hand side which can assume four positions- position 0: one or two persons in the front seats, full fuel tank, fully equipped (vehicle in running order);- position 1: five persons;- position 2: five persons with full luggage compartment (about 50 kg);- position 3: driver and 300 kg load, all stowed in the luggage compartment (full load);The setting is memorized and shown in the instrument panel display; the latter manages the control logic described above directly.The device is enabled only with the dipped beams on.The relay which controls the engagement of the dipped headlamps also supplies the adjustment motors inside the headlamps; this relay for switching the dipped headlamps on is managed by the Body Computer: relay energizing is activated by enablement signals with key in the ON (INT) position and with the dipped headlamps on. See E2011 DIPPED HEADLAMPSOn versions with gas discharge headlamps, the light beam is adjusted automatically and the two buttons in the middle of the dashboard, left hand side are not activated. |