198000612 - E5070 PARTICLE FILTER SYSTEM - FUNCTIONAL DESCRIPTION

FUNCTIONAL DESCRIPTION

Engine management control unit M10 controls and governs the entire electronic ignition and injection system.Main injection relay T9 of B1 controls the entire system: this is protected by a line protected by fuse F18 of engine compartment junction unit B1 and is energized by a control signal (earth) from pin 72 of connector A of control unit M10 and thus sends a power supply:- to pin 1 of connector A of the control unit, via the line of fuse F17 of B1 ;- to pin 5 of connector A of the control unit, via the line for fuse F22 of B1;The engine management control unit M10 receives signals from the different sensors thereby keeping all the engine operating parameters in check, in particular there are three specific sensors for the management of the operation of the particle filter.The FAP differential pressure sensor K187 receives a power supply from the control unit M10 from pin 44 of connector A and a reference earth from pin 37 of connector A and sends a signal proportional to the pressure to pin 36 of connector A of M10.The downstream catalyzer temperature sensor K189 receives a reference earth from pin 35 of connector A of the control unit M10 and supplies a signal proportional to the temperature measured at pin 34 of connector A of control unit M10.The downstream catalyzer temperature sensor K190 receives a reference earth from pin 33 of connector A of the control unit M10 and supplies a signal proportional to the temperature measured at pin 32 of connector A of control unit M10.The control unit is then connected via the CAN to the Body Computer M1 and to the instrument panel E50 thereby controlling the switching on of the filter blocked warning light and the displays in the panel.The control unit M10 is connected directly to the instrument panel E50 through a signal that comes out of pin 71 of connector A of M10 that is connected to the EOBD warning light.The autodiagnostic data can be read by connecting to connector C of the Body Computer M1 - pin 7: it receives signals from pin 25 of connector A of control unit M10 via the special diagnostic line, through which the command for the forced regeneration using the diagnostic equipment (Examiner) also "passes".