198002001 - 0010M80 180,000KM SERVICE

- Check the tyre tread is not worn.
Some types of tyre are fitted with wear gauges; they should be replaced as soon as these gauges are visible on the tread.
Do not swap tyres across.
- Check the tyre inflation pressure is correct. Also check the spare wheel.
The tyre pressures must be checked when they are cold.
- Check that the lighting system is operating correctly: headlamps, turn signals, hazard lights, luggage compartment lights, passenger compartment light and instrument panel warnings lights.- Check the windscreen wiper system is operating correctly and adjust the sprays if necessary.- Check the front and rear wiper blades are correctly positioned and not worn.- Check condition and wear of the front/rear disc brake pads and operation of pad wear indicator- Carry out a visual check of: exterior bodywork, underbody protection, rigid and flexible pipes (exhaust - fuel system - braking system) rubber elements (boots - hoses - bushes - etc.)- Check cleanliness of locks, bonnet and boot lids, cleanliness and lubrication of linkage- Visually inspect the condition of the accessory drivebelt.- Visually inspect the wear of the toothed timing drive belt (1.9 JTD 8v version); with reference to    Op. 1032D26 TIMING SYSTEM FRONT PROTECTIVE COVER (UPPER PART) - R.R.- Check and, if necessary, adjust the tappet clearance (1.9 JTD 8v version); refer to    Op. 1036H14 VALVE TAPPETS - CHECK CLEARANCE     Op. 1036H10 VALVE TAPPETS - CHECK AND ADJUST CLEARANCE, IF NECESSARY - Check exhaust emissions; refer to    Op. 1080A10 IDLING C.O. LEVEL - CHECK WITH SPECIAL EQUIPMENT     Op. 1080A20 EXHAUST FUMES - CHECK WITH OPACIMETER- Replace the fuel filter; refer to    Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE - Replace the air cartridge filter; refer to    Op. 1048A14 AIR CLEANER FILTER ELEMENT - REPLACE. - Restore the engine coolant level; refer to    Op. 0010T21 ENGINE COOLANT - CHECK DENSITY AND TOP UP, IF NECESSARY - Restore the battery fluid, windscreen washer fluid level, etc.- Check the operation of the engine control systems (using the diagnostic socket).- Change engine oil and oil filter (or every 24 months); refer to    Op. 0010T12 ENGINE OIL AND FILTER - REPLACE
Only for versions with DPF, the actual interval for changing the oil and replacing the engine oil filter depends on the vehicle usage conditions and is signalled by the warning light or message (if present) in the instrument panel
- Change brake fluid (or every 24 months)    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR - Replace the pollen filter (or every 12 months); refer to:    Op. 5010B08 CLIMATE CONTROL OUTSIDE AIR PURIFYING (POLLEN) FILTER - R.R. At the end of the service, connect the Examiner diagnostic equipment to the on board diagnostic socket to zero the mileage counter for the days to the starting value and write the details of the service that has been carried out (date, service no., total mileage) in the Trip Computer memory which can only be read using the diagnostic equipment.
Check that the figure has been set in the instrument panel in km or miles depending on the unit of measurement in that country.