198002058 - 1060F10 FUEL INJECTORS - R.R.

Removing ( Refitting )     Op. 1016A10 SOUND-PROOFING COVER - R.R     Op. 5530B10 BATTERY - R+R     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 1048B27 RIGID PIPE FOR AIR INLET TO THROTTLE BODY - R R    Op. 1060G50 THROTTLE BODY - R.R     Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R     Op. 1060F36 PIPES (ALL) FROM FUEL MANIFOLD TO INJECTOR - R.R. 1. Manually push clips (1a) and disconnect pipe from injectors to fuel recovery manifold (1b), injector side.
1. Undo the nuts fixing the injector mounting brackets.2. Position tool (2a) for extracting injectors, taking care to position lifting bracket (2b) under polygonal area (2c) of the injector.
ToolDescriptionFunctionValidity
1870739000ExtractorRemoving injectors1.9 JTD 8v
If new injector/s is/are fitted:- determine the identification code stamped on the top surface;- check, using an Examiner, that the new injector(s) is (are) recognized by the engine management control unit.
3. Position second lifting bracket for tool (3a) under injector retaining bracket (3b).4. Tighten nut (4a) for tool and remove injector assembly (4b).- Repeat the operation for the remaining injectors.
Refitting ( Removing ) - Place the injectors in their seats, complete with brackets, and fasten them by tightening the nuts to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Injector bracketsNutM82.7 ÷ 3.31.9 JTD 8v
- Connect the pipe from the injectors to the fuel recovery manifold to the injectors and push home until the clips click into place.    Op. 1060F36 PIPES (ALL) FROM FUEL MANIFOLD TO INJECTOR - R.R.     Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R     Op. 1060G50 THROTTLE BODY - R.R     Op. 1048B27 RIGID PIPE FOR AIR INLET TO THROTTLE BODY - R R    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 5530B10 BATTERY - R+R     Op. 1016A10 SOUND-PROOFING COVER - R.R