198000288 - 2125C30 GEAR ENGAGEMENT/SELECTION CABLES - R.R

Removing ( Refitting )     Op. 2125C02 GEAR CONTROL LEVER OUTER GAITER R R     Op. 1076B20 REAR EXHAUST SILENCER - R + R - For versions without DPF only:    Op. 1080B62 CATALYTIC CONVERTER - R + R - For versions with DPF only:    Op. 1080B81 PARTICULATE FILTER (D.P.F.) - R.R.    Op. 1076A56 EXHAUST PIPE INTERMEDIATE HEAT SHIELD R R     Op. 2125C32 GEARBOX HAND CONTROL LEVER MOUNTING - R.R.    Op. 5530B10 BATTERY - R+R     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R 1. Open the retaining clips for the gear selection and engagement cables.
1. Lift up the retaining clips (1a), disconnect and remove the gear selection and engagement cables (1b) from the reaction bracket.
Refitting ( Removing )     Op. 2125C32 GEARBOX HAND CONTROL LEVER MOUNTING - R.R.    Op. 1076A56 EXHAUST PIPE INTERMEDIATE HEAT SHIELD R R - For versions without DPF only:    Op. 1080B62 CATALYTIC CONVERTER - R + R - For versions with DPF only:    Op. 1080B81 PARTICULATE FILTER (D.P.F.) - R.R.    Op. 1076B20 REAR EXHAUST SILENCER - R + R 1. Position the gear lever (1a) in contact with the reverse gear inhibitor (1b).
1. Loosen the adjustment nut on the gear selection and engagement assembly.2. Position the spacer and a 0.5 mm thick washer beneath the gear selector lever to achieve an overall height (spacer + washer) of 18 mm.
ToolDescriptionFunctionValidity
1870974000SpacerAdjusting flexible cables1.9 JTD
3. Connect the gear selector cable.
- Secure the gear selection cable to the bracket using the safety plate.- Connect the gear engagement cable to the bracket using the safety plate.- Place the gear lever in Reverse and remove the tool complete with washer.- Close the retaining clips for the gear selection and engagement cables.    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 5530B10 BATTERY - R+R     Op. 2125C02 GEAR CONTROL LEVER OUTER GAITER R R