198002547 - 7210E72 R.R. FUEL FILLER BUSH WITH WING REMOVED
Removing
(
Refitting
)
Op. 7210E52 R.R. REAR WING - Ensure that the components connected are not distorted by checking the bodyshell alignment measurements with suitable equipment (gauges, templates or jigs).- Straighten the body as necessary.
- Use a rotary brush to remove the paint and gain access to the spot welds.1. Use the drill and chamfer the spot welds shown in the diagram not accessible with the chamfering machine.- Use a hammer and chisel to remove the previously chamfered spot welds.2. Remove the part from the vehicle, detaching the sealant at the base.
- Remove the spot weld residues using a disc grinder.- Use a rotary brush to clean the areas treated previously.1. Apply electro-galvanizing paint.
Refitting
(
Removing
)
1. Remove the anti-corrosion treatment from the entire perimeter of the inside and outside of the replacement part using a rotary brush.2. Drill out the part at the indicated points.- Apply electro-weldable paint to the edges involved.- Apply a bead of sesalant to the base of the part.
1. Position the replacement part correctly on the vehicle and secure it using self-locking clamps.- Check the alignment and the surrounding gaps.2. Use a MIG welder to fill weld the openings made previously.
1. Use a disc grinder to level the welds.- Use a rotary brush to clean the previously welded areas.
1. Apply anti-oxidant protection to the areas involved in the welding.- Seal the join lines between the replacement part and the vehicle.
Removing
(
Refitting
)
Op. 7210E52 R.R. REAR WING - Ensure that the components connected are not distorted by checking the bodyshell alignment measurements with suitable equipment (gauges, templates or jigs).- Straighten the body as necessary.
