198003024 - 1016E38 SINGLE CYLINDER HEAD OR (ONE) LEFT OR RIGHT, REMOVED - GRINDING

- Check that the planarity of the lower cylinder head plane corresponds to the recommended values.
MeasurementValueValidity
Engine cylinder head lower surface flatness (mm)< 0.1
1. If the lower surface flatness of the lower cylinder head is not within specified values, grind from the nominal head height and then fit a new gasket with the number of notches determined as described below.a - The head may be levelled to 0.1 m if starting from a gasket with no references and using a new gasket with one reference.b - The head may be levelled to 0.2 m if starting from a gasket with no references and using a new gasket with two references.c - The head may be levelled to 0.1 m if starting from a gasket with one reference and using a new gasket with two references.
When within limit conditions (head gasket with 2 notches before levelling), the lower cylinder head surface cannot be levelled.
MeasurementValueValidity
Cylinder head nominal height (mm)107 +/- 0.051.9 JTD 16v