198001856 - K100 MIL WARNING LIGHT NOT WORKING (REMAINS OFF BEFORE STARTING)

The MIL warning light does not come on with the ignition on;
the engine failure warning light is switched on by means of an earth command directly from the "engine management node"; during normal operation the engine failure warning light should come on when the ignition is on and go out when the engine is started up.
1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
Connect the diagnostic equipment to the diagnostic socket and check the operation of the engine failure warning light through active diagnosis at the engine management nodeMove on to Step 21.The warning light does not come on1.Renew the correct wiring    See E4010 INSTRUMENT PANEL
2.The warning light comes on2.Replace instrument panel    Op. 5560B10 CONTROL PANEL - R+R
2CORRECT OPERATION CHECKALL OKPROBLEMS ENCOUNTEREDACTION
petrol engines:Check that the fault is no longer presentEnd of diagnosisFault persistsReplace the engine management control unit    Op. 1056B82 INJECTION/IGNITION SYSTEM E.C.U. (ONE) - R + R
JTD engines:Check that the fault is no longer presentEnd of diagnosisFault persistsReplace the engine management control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R