P030 NO DOORS / BOOT OPEN BUZZER SIGNAL WITH CAR IN MOTION - Fiat - NUOVA BRAVO - eLearn

198001923 - P030 NO DOORS / BOOT OPEN BUZZER SIGNAL WITH CAR IN MOTION

With the vehicle moving, the accidental opening of one of the doors or the boot lid is not signalled by the buzzer.

The instrument panel node acquires the status signal for the doors, the boot lid, the bonnet lid and the vehicle speed from the network. If one of the doors or the boot lid or the bonnet lid is open and the speed of the vehicle is above 4 Km/h, a warning signal is produced.

1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
		Test results
	Connect the Examiner diagnostic equipment and check, in the parameters ambient, that the switch status for the doors (front and rear) and boot lid has been correctly learnt	Move on to Step 2	1. Malfunction in the acquisition of all the statuses for the switches for the doors (front and rear) and boot lid2. Malfunction in the acquisition of one of the statuses for the switches for the doors (front and rear) or boot lid	1. Restore the correct connection for the electrical connectors at the body computer node2. Restore the electrical connection between the switch for the door or boot lid and the body computer node see Wiring Diagram See E3040 CENTRAL LOCKING
2	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Keeping the Examiner diagnostic equipment connected, check the following at the body computer node:- that there are no errors at the C-CAN line;- that there are no speedometer signal errors	Move on to Step 3	1. Error detected at the C-CAN line2. Error detected in the speedometer signal	1. Continue following the instructions on the diagnostic equipment2. See table K003 SPEEDOMETER NOT WORKING
3	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Keeping the Examiner diagnostic equipment connected, check the following at the instrument panel node:- that there are no errors at the B-CAN line;- that there are no speedometer signal errors	Move on to Step 4	1. Error detected at the B-CAN line2. Error detected in the speedometer signal	1. Continue following the instructions on the diagnostic equipment2. See table K003 SPEEDOMETER NOT WORKING
4	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace the instrument panel node Op. 5560B10 CONTROL PANEL - R+R