Fit the excess pressure sensor (2) on the tool (1) N° 1871003500 and secure it using the bolt (3).Connect the electrical connection for the pressure relief sensor.Connect the EX09 tool (4) from box N° 1806338000 to tool N° 1871003500 and connecto connector (5) N° 2000017500
Connect the 5 bar pressure transducer EX06 to the tool and connect it to the Examiner card using cable EX01.Position the Examiner diagnostic equipment in the passenger compartment and make the connections.Select "pressure gauge" on the Examiner and prepare for the acquisition of data in "intake pressure" mode with a 2000 mmHg end of scale and selection time of 10 seconds.Road test the vehicle (sticking to the speed limits in force) as follows:On an out of town route with 3rd gear engagedInitiate the acquistion by pressing start on the diagnostic equipment and 5 seconds later fully depress the accelerator pedal until the engine speed is 3000 rpm.Once this speed is reached completely release the accelerator pedal.Display the resulting graph and read a value of 2100 and 22300 mbar for the maximum peak (1596 - 1748 mmHg) corresponding to a supercharging value of 1100 - 1300 mbar.
Disconnect the Examiner and the pressure transducer.Detach the electrical connection from the pressure relief sensor.Unscrew the bolt and remove the excess pressure sensor from the tool.Remove the tool for checking the supercharging pressure.Proceed with refitting the excess pressure sensor Op. 1060G16 EXCESS PRESSURE SENSOR - R.R. Proceed with refitting the sound insulation cover Op. 1060E10 DIESEL INJECTION PRESSURE PUMP - R.R.
