| STEP | CHECK TO BE PERFORMED | REMEDIAL ACTION IF THE CHECK IS NOT OK |
|---|
| 1 | Heater plugs absorption checkCheck that the battery voltage is not below 12.6 VPlace the 1000 Amp ammeter clamp for the Examiner equipment on the lead of the glow heater plug being tested.Turn the key to the MAR position and check the current uptake of the glow heater plugThe peak average rated current level must be 15AChecks must be carried out at a constant voltage of 11 VIf the heater plugs do not heat up correctly move on to Step 2 | Restore the electrical continuity for the supply leads for the heater plugs coming from the preheating control unit. |
| 2 | Glow heater plugs power supply check. With the ignition key in the MAR position (engine cold) check that the power supply for the individual glow heater plugs is correct during the preheating stage. | Restore the electrical continuity for the supply leads and for the cable coming from the engine control unit and ensure the cables and the connections for the wiring involved are correctly fastened See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT If the check is OKReplace glow heater plug control unit Op. 5520C20 HEATER PLUGS CONTROL UNIT - R.R If the check is OKReplace the engine management control unit Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R |
| 3 | Glow heater plugs checkDisconnect the wiring from the heater plug in questionUsing the Examiner in the ohmmeter function, connect the probes between the body of the heater plug and the threaded end of the heater plug.Check that the resistance for each individual heater plug is between 0.5 and 1 Ohm at 20°C | Replace the heater plug Op. 5520C10 HEATER PLUGS - R+R |
