198000026 - 1820B58 CLUTCH HYDRAULIC CIRCUIT VIBRATION DAMPER - R+R

Removing ( Refitting ) - Unscrew the brake fluid reservoir cap and fit the tool.
ToolDescriptionFunctionValidity
2000001400PlugBrake/ clutch system vacuum
1. Retract the clip and disconnect the oil supply pipe to the operating cylinder from the three-way connector.- Open the intermediate pipe retaining clip from the vibration damper to the operating cylinder.
1. Open the pipe retaining clip from the reservoir to the clutch pump.2. Lift up the clip, disconnect the vibration damper complete with supply pipe to the operating cylinder and remove it.
1. Undo the connector (1a) and separate the vibration damper (1b) for the operating cylinder supply pipe (1c).- Remove the O-ring.
Refitting ( Removing ) - Fit a new O-ring on the vibration damper connector, clutch pump side.- Connect the operating cylinder supply pipe to the vibration damper and tighten the connector.- Place the vibration damper and operating cylinder supply pipe assembly in position.- Connect the vibration damper to the clutch pump and attach the retaining clip.- Close the pipe retaining clip from the reservoir to the clutch pump.- Connect the fluid pipe to the operating cylinder, three-way connector side and secure it using the retaining clip.- Close the intermediate pipe retaining clip from the vibration damper to the operating cylinder.    Op. 0010T67 HYDRAULIC CLUTCH SYSTEM - BLEED AIR