198000240 - 1032B44 TOOTHED DRIVE PULLEY - R + R WITH TIMING BELT REMOVED

Removing ( Refitting )     Op. 1064A31 HEAT SHIELD FOR TURBOCHARGER - R.R.    Op. 1076A48 CATALYTIC CONVERTER HEAT SHIELD - R.R 1. Fit a suitable (6 mm diameter) peg on the flywheel via the special opening in the gearbox to be used for counter-torque.
Check that the pin is correctly inserted in the housing in the flywheel.
1. Fit the tool.
This operation is necessary, in spite of the flywheel lock having been fitted, to lock the pulley preventing it from bending during the loosening/tightening of the fixing bolt with consequent damage to the internal locating pin.
ToolDescriptionFunctionValidity
2000004500TemplateCrankshaft timing1.4 16v
2. Undo the toothed drive pulley fixing bolt.- Remove the template.3. Remove the toothed drive pulley
Refitting ( Removing ) - Place the toothed drive pulley in its housing.- Fit the tool.
ToolDescriptionFunctionValidity
2000004500TemplateCrankshaft timing1.4 16v
- Tighten the bolt fixing the toothed drive pulley to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Crankshaft gearBoltM121.9 ÷ 2.1 + 107° ÷ 113°1.4 16v
- Remove the template.- Remove the peg used for counter-torque from the opening in the gearbox.     Op. 1076A48 CATALYTIC CONVERTER HEAT SHIELD - R.R    Op. 1064A31 HEAT SHIELD FOR TURBOCHARGER - R.R.