198000288 - 2125C30 GEAR ENGAGEMENT/SELECTION CABLES - R.R

Removing ( Refitting ) - Position the gear lever in neutral.     Op. 2125C02 GEAR CONTROL LEVER OUTER GAITER R R     Op. 1076B30 FRONT EXHAUST SILENCER - R + R     Op. 1076A42 FRONT EXHAUST SILENCER FRONT HEAT SHILED R R     Op. 2125C32 GEARBOX HAND CONTROL LEVER MOUNTING - R.R. 1. Open the clip securing the gear selection and engagement cables to the bodyshell. 1. Insert the locking pin with the gear selector and engagement unit in neutral.2. Disconnect the gear selector and engagement cables.3. Adjust the clips and disconnect the gear selection-engagement cables from the reaction bracket. - Remove the gear selection and engagement flexible rods, releasing them towards the engine compartment. Refitting ( Removing ) - Place the gear selection and engagement cable rods in position.     Op. 2125C32 GEARBOX HAND CONTROL LEVER MOUNTING - R.R.    Op. 1076A42 FRONT EXHAUST SILENCER FRONT HEAT SHILED R R     Op. 1076B30 FRONT EXHAUST SILENCER - R + R - Close the clip securing the gear selection and engagement cables to the bodyshell.- Place the gear lever in neutral and move it to the left (driver''s side) and lock it in this position.1. Prepare the auto-adjustment device (quick adjuster) located on the gear selection cable by pulling the component (1a) backwards and lowering the spring (1b); release the component (1a) to keep the spring (1b) in position. - Remove the locking dowel for the gear selection and engagement unit.- Check the gear selection/engagement by moving the gear control lever and make sure that the self-adjustment device (quick adjuster) slides on the terminal.    Op. 2125C02 GEAR CONTROL LEVER OUTER GAITER R R