Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)
| | Test results |
| 1 | CHECK ON INSTALLATION OF ALIGNMENT SENSORS | All OK | Problems encountered | Operation |
|---|
| Check the condition and correct installation of the front and rear attitude sensors. Ensuere that the bracket and rod are secured correctly for both front and rear sensors | Move on to Step 2 | Mechanical installation of front sensor (brackets, connecting rods) incorrect | Refit front sensor correctlyOp. 5540C42 SENSOR FOR CORRECTING/ALIGNING GAS DISCHARGE LIGHTING UNITS ON FRONT SUSPENSION - R.R. |
| Mechanical installation of rear sensor (brackets, connecting rods) incorrect | Refit rear sensor correctlyOp. 5540C46 SENSOR FOR CORRECTING/ALIGNING GAS DISCHARGE LIGHTING UNITS ON REAR SUSPENSION - R R |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Check that there are no errors by connecting to the master headlamp (left side) control unit. | Move on to Step 3 | Presence of error B1020 detected - Front sensor signal | Move on to Step 3 |
| Presence of error B1021 detected - Rear sensor signal | Move on to Step 3 |
| Presence of error B1022 detected - Sensor supply | Move on to Step 3 |
| Presence of error B1040 detected - Headlamp alignment corrector | Move on to Step 5 |
| 3 | CHECK ON ALIGNMENT SENSOR SUPPLY | All OK | Problems encountered | Operation |
|---|
| Check that the attitude sensors are receiving a correct supply by carrying out the test See Test 5540BB CHECK ALIGNMENT SENSORS | Move on to Step 4 | | |
| 4 | CHECK ON CONNECTIONS INSIDE THE HEADLAMPS | All OK | Problems encountered | Operation |
|---|
| Check that the connections inside the headlamps for the vertical adjustment motors are correctly connected See E3080 HEADLAMP AGLINMENT CORRECTOR | Move on to Step 5 | Connector for right headlamp motor not correctly fitted | Fit connector for right headlamp |
| Connector for left headlamp motor not correctly fitted | Fit connector for left headlamp |
| 5 | CHECK ON OPERATION OF HEADLAMP ALIGNMENT ACTUATORS | All OK | Problems encountered | Operation |
|---|
| Replace the left headlamps Op. 5540B81 LEFT GAS DISCHARGE LIGHT CLUSTER - R.R.and right Op. 5540B82 RIGHT GAS DISCHARGE LIGHT CLUSTER - R.R.and check that the motors are working properly | End of diagnosis | Right headlamp alignment corrector not working | Move on to Step 6 |
| Left headlamp alignment corrector not working | Move on to Step 6 |
| 6 | CORRECT OPERATION CHECK | All OK | Problems encountered | Operation |
|---|
| Refit the headlamp removed previously and replace the ballast control unitOp. 5540B40 and/orOp. 5540B41 | End of diagnosis | | |