198001814 - K015 CLOCK NOT WORKING

With the ignition on, the display either does not show the time or it is not correct.

		TEST RESULTS
1	INSTRUMENT PANEL FUNCTIONS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check:- That the display shows the correct time- That it is possible to adjust the time- That the clock moves forward	Move on to Step 2	1. The time displayed is not correct2. It is not possible to adjust the time3. The clock stays still4. The display/time is not clear	1. Adjust the time2. Move on to Step 43. Replace the instrument panel    Op. 5560B10 CONTROL PANEL - R+R 4. Move on to Step 2
2	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment to the diagnostic socket.Check that there are no faults in the instrument panel	Move on to Step 3	Presence of errors	Continue following the instructions for the diagnostic equipment
3	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Keeping the Examiner equipment connected to the diagnostic socket, check the operation of the display in active diagnosis.	End of diagnosis	Display defective	Replace the instrument panel    Op. 5560B10 CONTROL PANEL - R+R
4	ELECTRICAL CIRCUIT CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check:- Connections between centre control panel in dashboard and instrument panel- Control panel earth    See E4010 INSTRUMENT PANEL	Move on to Step 5	Connections defective, earth or power supply defective	Restore the correct connections, if necessary, replace the wiring.
5	MODE BUTTON CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the MODE button is working properly see wiring diagram    See E4010 INSTRUMENT PANEL	End of diagnosis	MODE button defective	Replace the left control panel    Op. 7040A56 SWITCH UNIT IN DASHBOARD - R.R.