198002044 - 1048B25 INTERMEDIATE RIGID PIPE BETWEEN HEAT EXCHANGER AND THROTTLE BODY - R R
Removing
(
Refitting
)
1. Undo the bolt and remove the air pressure sensor without disconnecting the connection.2. Loosen the band and disconnect the turbocharging by-pass pipe from the rigid pipe.3. Loosen the band and disconnect the air inlet hose to the throttle body from the rigid pipe.4. Undo the nut securing the rigid pipe to the connector carrier bracket.
1. Undo the nut securing the rigid pipe to the gearbox bracket.2. Loosen band (2a) and remove rigid pipe (2b).
Refitting
(
Removing
)
- Place the rigid pipe back in its housing, connect it to the heat exchanger air inlet sleeve and tighten the associated band.- Tighten the nut securing the rigid pipe to the gearbox bracket.- Connect the air intake hose to the throttle body to the rigid pipe and tighten the band.- Tighten the nut securing the rigid pipe to the connector carrier bracket.- Connect the turbocharging by-pass pipe to the rigid pipe and tighten the band.- Position the air pressure sensor in its housing and secure it using the bolt.
Removing
(
Refitting
)
1. Undo the bolt and remove the air pressure sensor without disconnecting the connection.2. Loosen the band and disconnect the turbocharging by-pass pipe from the rigid pipe.3. Loosen the band and disconnect the air inlet hose to the throttle body from the rigid pipe.4. Undo the nut securing the rigid pipe to the connector carrier bracket.
