7050D35 LEFT REAR SEAT BACKREST COVER (TWO SEATER) - R.R. WITH BACKREST REMOVED - Fiat - GRANDE PUNTO - eLearn

199000360 - 7050D35 LEFT REAR SEAT BACKREST COVER (TWO SEATER) - R.R. WITH BACKREST REMOVED

) Op. 7050B12 REAR SEAT HEAD RESTRAINT - R.R.1. Undo the bolts.2. Remove panel (2a) by releasing from seat belt (2b) through split (2c).3. Remove the handle moulding (3a) releasing the internal retainers (3b).

- Fold down the backrest.1. Open the covers.2. Undo the bolts.3. Remove the fastening device panel.4. Undo the bolt.5. Remove the retainer panel.

1. Remove the end parts (1a) (1b) and (1c) of the zip fastener.2. Use pliers to remove the end clips (2a) and (2b).3. Open zip fasteners (3a) and (3b) along their length.4. Use pliers to remove the end clamp (4a).5. Open zip fastener (5a) along its length, only using cursor (5b) (in the repair kit). Insert in the position shown in the figure.

If zip (5a) is not opened using slide (5b), it may not be possible to reclose it correctly during refitting.

6. Release cover terminal retainer (6a) from seat (6b) on the structure.

1. Fold down the seat and prise up the cover (1a) from padding (1b), as far as possible.2. Undo retainers (2a) and (2b) and remove left and right head restraint guide bushes (2c) and (2d) from the backrest structure.3. Remove the trim.

- If necessary, separate the backrest trim from the padding as described below.1. Prise up the trim by releasing from the padding edge.2. Use cutters to cut all the front backrest trim retainers.3. Separate the trim (3a) from padding (3b).

Refitting ( Removing

) - Check that the backrest trim is not damaged.- If removed, position the backrest trim on the padding and crimp the retainers using special pliers.

Mould the cover on the upholstery during the various refitting stages.

- Fit the trim on the upper padding area.- Place the head restraint bushes in position and attach the retainers.

Both head restraint bushes have different retainers and engagement seats.

- Position the padding on the seat frame and fit the backrest cover on the padding.- Attach the cover terminal retainer to its seat on the structure.1. Close zip fastener (1a) using cursor (1b) in the repair kit.Remove the slide and apply a retaining clamp (1c) to the end of the zip fastener.2. Close zip fastening (2a) using the slide already applied when removing the cover.Remove the slide and apply a retaining clamp (2b) to the end of the zip fastener.3. Close zip fastener (3a) using the cursor removed from zip fastener (2a).Remove the slide and apply a retaining clamp (3b) to the end of the zip fastener.4. Fit zip fastener terminals (4a) (4b) (4c) inside the cover.

- Position the retainer panel assembly and tighten the bolt.- Position the device panel and tighten the bolts.- Close the covers.- Fold down the backrest.- Position the handle panel and do up the internal retainers.- Attach the panel to the seat belt through the split, then position in place.- Tighten the bolts. Op. 7050B12 REAR SEAT HEAD RESTRAINT - R.R.