| | Results of the tests |
| 0 | PRELIMINARY CHECKS | All OK | Problems encountered | Operation |
|---|
| For the 1.9 JTD;Steer to the right or to the left and check whether the noise increases. | Move on to Step 1 | The noise changes whilst steering | Proceed as instructed See table S015 NOISE WHILST DRIVING |
| 0 | PRELIMINARY CHECKS | All OK | Problems encountered | Operation |
|---|
| For the 1.2 8v, 1.4 8v, 1.3 JTD;Steer to the right or to the left and check whether the noise increases. | Move on to Step 3 | The noise changes whilst steering | Proceed as instructed See table S015 NOISE WHILST DRIVING |
| 1 | CHECK THE PAD TYPE AND SURFACE | All OK | Problems encountered | Operation |
|---|
| For the 1.9 JTD;Check:- the condition of the pad braking surfaces;- pad type | Move on to Step 2 | 1. Front braking surfaces vitrified or with traces of grease, oil or water. Pads not the recommended type2. Rear braking surfaces vitrified or with traces of grease, oil or water. Pads not the recommended type | 1. Re-clean, check and remove the fault causes. Replace the pads if necessary Op. 3310A60 FRONT BRAKE PADS - REPLACE 2. Re-clean, check and remove the fault causes. Replace the pads if necessary Op. 3310B62 REAR BRAKE PADS - REPLACE |
| 2 | CHECK DISCS | All OK | Problems encountered | Operation |
|---|
| For the 1.9 JTD;Check the condition of the brake discs | End of diagnosis | 1. Front discs worn or damaged2. Rear discs worn or damaged | 1. Replace the front discs2. Replace the rear discs |
| 3 | CHECK FOR THE PRESENCE OF IRON FILINGS | All OK | Problems encountered | Operation |
|---|
| For the 1.2 8v, 1.4 8v, 1.3 JTD;Remove the drum and check for the presence of iron filings in the drum and the shoes | Move on to Step 4 | Presene of iron filings in the drum and the shoes | Clean the iron filings from the drum and the shoes | Refit the drum tighten the wheel bolts to the recommended torque |
|
| 4 | CHECKS ON THE DRUM | All OK | Problems encountered | Operation |
|---|
| For the 1.2 8v, 1.4 8v, 1.3 JTD;Check whether the drum is oval using suitable measuring equipment | Move on to Step 5 | Drum oval | Replace the drum Op. 3320B30 REAR BRAKE DRUM (ONE), LEFT OR RIGHT - R.R. |
| 5 | CHECKS ON THE WHEEL HUB | All OK | Problems encountered | Operation |
|---|
| For the 1.2 8v, 1.4 8v, 1.3 JTD;Check the following on the wheel hub:- circularity;- radial clearances;- axial clearances | End of diagnosis | 1. Excessive circularity2. Excessive radial clearance3. Excessive axial clearance | 1. Replace the hub Op. 4450D10 HUB FOR ONE REAR WHEEL, L/H OR R/H - R+R WITH WHEEL REMOVED - CHECK WHEEL GEOMETRY SEPARATELY 2. Replace the hub Op. 4450D10 HUB FOR ONE REAR WHEEL, L/H OR R/H - R+R WITH WHEEL REMOVED - CHECK WHEEL GEOMETRY SEPARATELY 3. Replace the hub Op. 4450D10 HUB FOR ONE REAR WHEEL, L/H OR R/H - R+R WITH WHEEL REMOVED - CHECK WHEEL GEOMETRY SEPARATELY |