| | Test results |
| 1 | ELECTRICAL SYSTEM CHECK | All OK | Problems encountered | Operation |
|---|
| Check the condition of the protective fuse in the engine compartment junction unit. See E2012 MAIN BEAM HEADLAMPS | Move on to Step 2 | Fuses blown | Check the wiring insulation by continuing to step 3, then replace the fuses See E2012 MAIN BEAM HEADLAMPS |
| 2 | BULB CONDITION CHECK | All OK | Problems encountered | Operation |
|---|
| Check the condition of the high beam bulbs | Move on to Step 3 | Bulbs burnt out | Replace the bulbs Op. 5540B24 MAIN BEAM BULB (ONE) FOR ONE HEADLAMP/LIGHT CLUSTER LH OR RH - R.R |
| 3 | ELECTRICAL SYSTEM CHECK | All OK | Problems encountered | Operation |
|---|
| Check the continuity and the insulation of the wiring between the front lamp and the Engine Compartment Control Unit See E2012 MAIN BEAM HEADLAMPS | Move on to Step 4 | Electrical connections broken or lacking insulation | Renew the electrical connections See E2012 MAIN BEAM HEADLAMPS |
| 4 | ELECTRICAL SYSTEM CHECK | All OK | Problems encountered | Operation |
|---|
| Check the continuity and the insulation of the wiring between the outlet connector for the Engine Compartment Control Unit and the Protective Fuse See E2012 MAIN BEAM HEADLAMPS | Move on to Step 5 | Interruption or no insulation for the Dashboard Junction Unit internal connection | Replace the engine compartment junction unit Op. 5505A13 ADDITIONAL JUNCTION UNIT IN ENGINE COMPARTMENT - R.R. |
| 5 | LIGHT CLUSTER ELECRICAL CIRCUIT CHECK | All OK | Problems encountered | Operation |
|---|
| Check the condition of the wiring inside the light cluster between the headlamp connector and the high beam bulb | Move on to Step 6 | Internal wires broken or not insulated | Restore the electrical connection, if necessary, replace the front light cluster Op. 5540B07 LEFT FRONT HEADLAMP - R.R and/or Op. 5540B08 RIGHT FRONT HEADLAMP - R.R |
| 6 | LIGHTING STALK CHECK | All OK | Problems encountered | Operation |
|---|
| Connect an Examiner to the Body Computer node to check the correct operation of the light stalk contacts on the high beam position | Move on to Step 7 | Light stalk defective | Replace the stalk Op. 5550A10 STALK UNIT ASSEMBLY - R+R |
| 7 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | Fault persists | Replace body computer Op. 5505A32 BODY COMPUTER - R.R |
