199001691 - 0010T47 HYDRAULIC SYSTEM FLUID FOR GEARBOX WITH HYDRAULIC SELECTION CHECK LEVEL AND TOP UP, IF NECESSARY

    Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R.- The quantity of fluid required to refill the reservoir only is 600 cc- The quantity of fluid required to refill the hydraulic circuit and the reservoir is 700 cc

The hydraulic system fluid level should be checked with the fluid at ambient temperature (engine cold).

- Turn the ignition key to the ON position.- Carry out ten gear changes with the engine switched off (this operation is necessary to collect any traces of oil through recirculation).- Connect the Examiner diagnostic equipment.- Select and launch the "accumulator depressurization" service.- At the end of the above operation, the hydraulic circuit reservoir will be full of fluid.1. Check that the fluid level in the hydraulic circuit reservoir corresponds to the MAX reference shown in the diagram. - If the level is below the MIN mark, add recommended fluid until the level is midway between the MIN and MAX marks.

Component	Type	Description	Classification	Qty.	Validity
ROBOTIZED GEARBOX HYDRAULIC ACTIVATION SYSTEM	Oil	TUTELA CAR CS SPEED	ATF DEXRON III	0.7 litres0.59 kg	1.4 8v

The table shows the total quantity of fluid present in the electrohydraulic selection hydraulic system.

    Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R.