2127E40 HYDRAULIC SELECTION GEARBOX SPEED SELECTION POSITION SENSOR - R.R. - Fiat - GRANDE PUNTO - eLearn

199001704 - 2127E40 HYDRAULIC SELECTION GEARBOX SPEED SELECTION POSITION SENSOR - R.R.

) - Position the vehicle on a lift. Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R.1. Disconnect the electrical connection for the gear selector position potentiometer.

	Description	Connector
1	Gear selector potentiometer	See K068 SPEED SELECTION POTENTIOMETER

2. Undo the bolts (2a) and remove the gear selector position potentiometer (2b).3. Undo the bolts (3a) and remove the electro-hydraulic selection gearbox gear selector position sensor (3b).4. Remove the O-ring from the gear selector position sensor housing.

Refitting ( Removing

) - Fit a new O-ring in the special groove in the gear selector position sensor housing.- Place the electro-hydraulic selection gearbox gear selector position sensor back in its housing and secure it using the bolts.- Place the gear selector position potentiometer back in its housing and secure it using the bolts taking care to load the potentiometer.- Connect the electrical connection to the gear selector position potentiometer. Op. 0010T47 HYDRAULIC SYSTEM FLUID FOR GEARBOX WITH HYDRAULIC SELECTION CHECK LEVEL AND TOP UP, IF NECESSARY Op. 0010T48 HYDRAULIC SYSTEM FOR GEARBOX WITH HYDRAULIC SELECTION - BLEED AIR Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R.- Connect the Examiner and run the initialisation procedure for the gear selector/engagement position settings and check that the engagement position travel is correct.- Remove the vehicle from the lift.