199001819 - C026 THE CAR GOES INTO NEUTRAL BY ITSELF (WHEN CHANGING GEAR WHILST MOVING) (Robotized gearbox)

		Test results
1	ERRORS IN AUTOMATED GEARBOX CONTROL UNIT CHECK	All OK	Problems encountered	Operation
	Check that there are no errors in the automated gearbox control unit. More specifically:- error at selection solenoid;- error at engagement solenoids;	Move on to Step 5	One or more errors on the list are present.	Move on to Step 2
2	CHECKS ON FAULTS ENCOUNTERED	All OK	Problems encountered	Operation
	Check the faults, according to    See Test 2127OI WHAT TO DO DEPENDING ON THE ERROR PRESENT IN THE ROBOTIZED GEARBOX CONTROL UNIT	Move on to Step 3	Fault at the connections.	Restore/replace the wiring    See E7051 ROBOTIZED GEARBOX
			The active diagnosis is inconclusive and no wiring errors are detected (even or odd gears engagement).	Move on to Step 3.
3	ENGAGEMENT SOLENOID REPLACEMENT	All OK	Problems encountered	Operation
	If this step has been reached during the active diagnosis of the engagement solenoid, replace it    Op. 2127C52 ODD AND EVEN GEAR ENGAGEMENT SOLENOIDS - R.R. and check it is working correctly.	Move on to Step 4
4	REPLACEMENT OF SELECTION SOLENOID	All OK	Problems encountered	Operation
	If no connection / wiring faults are detected and the selection solenoid is in error, replace it    Op. 2127C54 GEAR SELECTION SOLENOIDS - R.R. and check it is working correctly.	Move on to Step 5
5	FLUID LEVEL CHECK	All OK	Problems encountered	Operation
	1. Check the fluid level, carrying out    See Test 2127OB FLUID LEVEL CHECK	Move on to Step 7	Level lower than Max mark	Top up and move on to Step 6
			Level above Max mark	Bring to Max level and move on to step 7
6	FLUID LEAKS CHECK	All OK	Problems encountered	Operation
	Check there are no fluid leaks, carrying out    See Test 2127OC FLUID LEAKS CHECK	Move on to Step 7	Fluid leaks detected.	Repair/replace the parts involved, top up the fluid with the correct amount.
7	FLUID PRESSURE CHECK	All OK	Problems encountered	Operation
	Check the fluid pressure, carrying out    See Test 2127OD FLUID PRESSURE CHECK Because of low pressure neutral is only available if the vehicle is at a standstill or is moving slowly (around 10-15 km/h)	Move on to Step 9	Pressure < 40 bar	Move on to Step 8
8	ELECTRIC PUMP OPERATION CHECK	All OK	Problems encountered	Operation
	Check that the electric pump is working properly by carrying out    See Test 2127OE ELECTRIC PUMP OPERATION CHECK	Move on to Step 9	Voltage less than 11 V	Restore correct battery voltage.
			It is not possible to shift gears using the lever.	Activate the "clutch bleeding" service using the Examiner Plus or Smart to activate the electric pump.
9	ENGAGEMENT OF ALL GEARS CHECK	All OK	Problems encountered	Operation
	Check that all the gears engage correctly, carrying out    See Test 2127OJ CHECK ON CORRECT ENGAGEMENT OF ALL THE GEARS VIA THE GEAR LEVER WITH THE ENGINE ON	End of diagnosis	The test is not successful.	Contact technical service for further information on the problem.