2127E10 HYDRAULIC SPEED SELECTION SYSTEM CONTROL UNIT - R.R. - Fiat - GRANDE PUNTO - eLearn

199001678 - 2127E10 HYDRAULIC SPEED SELECTION SYSTEM CONTROL UNIT - R.R.

) 1. Release and remove the electronic control unit protective trim.2. Undo the nuts (2a) and remove the electronic control unit protection (2b).

1. Disconnect the electrical connections for the electronic control unit.

	Description	Connector
1	Robotised gearbox control unit	See M054 ROBOTIZED TRANSMISSION CONTROL UNIT

2. Undo the nut (2a) and remove the electronic control unit (2b).

Refitting ( Removing

) - Place the electronic control unit in position and secure it using the nut.- Connect the electrical connections for the electronic control unit.- Place the electronic control unit in position and secure it using the nuts.- Place the electronic control unit protective trim back in its housing.- Only in the case of replacement, connect the Examiner and run the initialisation procedure for the gear engagement/selection positions and check that the engagement position travel is correct.