199001684 - 3330B24 BRAKE PEDAL - R.R. FOR VERSIONS WITH MANUAL GEARBOX WITH HYDRAULIC SELECTION

Removing ( Refitting )     Op. 5010C55 LOWER AIR DIFFUSER (ONE) LH OR RH - R.R (left side)    Op. 1068A20 ACCELERATOR PEDAL WITH BUILT-IN POTENTIOMETER - R.R 1. Working at the rear of the brake pedal, press the white retaining tabs (1a) securing the brake servo push rod (1b) to the brake pedal (1c).
1. Remove the black retaining device (1a), then release the brake servo push rod (1b) from the brake pedal (1c) and keep the brake servo push rod spherical head housing cover (1d).
After every dismantling operation, the black retaining device for the brake servo push rod (1a) must be removed even if it appears to be intact.
1. Withdraw pin (1a) and remove clutch pedal (1b).
Refitting ( Removing ) - Position the clutch pedal in its seat and secure with the pin.1. Fit the new retaining device (1a) on the brake pedal (1b) so that the fastening clips (1c) are secured; position the brake servo push rod spherical head housing cover (1d).
After each dismantling operation, the black coloured retaining device for the brake servo push rod must always be replaced even if it appears to be intact.
- Lift up the brake pedal and position the brake servo push rod by the retaining device.- Press the brake pedal to fit the brake servo push rod on the retaining device.    Op. 1068A20 ACCELERATOR PEDAL WITH BUILT-IN POTENTIOMETER - R.R     Op. 5010C55 LOWER AIR DIFFUSER (ONE) LH OR RH - R.R (left side)