199002463 - 7030B70 SUN ROOF MOVEMENT MOTOR - R+R

Removing ( Refitting ) - Remove the rear parcel shelf    Op. 7040G30 BOOT LIGHT BULB HOLDER - R.R.    Op. 7065C86 CURRENT SOCKET IN LUGGAGE COMPARTMENT - R.R.- Work on both sides    Op. 7040H42 REAR PILLAR TRIM (ONE), LEFT OR RIGHT- R.R     Op. 7040L40 FRONT DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R.     Op. 7050A22 REAR SEAT CUSHION - R+R    Op. 7040H38 CENTRE PILLAR UPPER ELEMENT (ONE), LEFT OR RIGHT - R.R     Op. 7040H30 FRONT PILLAR TRIM (ONE), LEFT OR RIGHT - R.R.     Op. 7065C34 SUN BLIND (ONE), LEFT OR RIGHT - R.R.     Op. 7040E10 FRONT COURTESY LIGHT - R+R - Remove all the grab handles.    Op. 7065C30 GRAB HANDLE (ONE) LEFT, RIGHT OR CENTRE PASSENGER COMPARTMENT INTERIOR - R.R     Op. 7030B64 SUN ROOF CONTROL SWITCH - R+R - Remove both the seals.    Op. 7030B34 SLIDING ROOF COMPARTMENT DECORATIVE SEAL - R+R     Op. 7040H16 ROOF PANEL LINING FOR VERSIONS WITH SUN ROOF - R.R 1. Disconnect the electrical connection.2. Undo the bolts.3. Remove the motor by releasing the pinion from the control cables. Refitting ( Removing ) - Check that the motor is not damaged.- Position the motor in its seat and engage the pinion with the control cables.- Tighten the bolts.- Connect the electrical connection.    Op. 7040H16 ROOF PANEL LINING FOR VERSIONS WITH SUN ROOF - R.R     Op. 7030B34 SLIDING ROOF COMPARTMENT DECORATIVE SEAL - R+R     Op. 7030B64 SUN ROOF CONTROL SWITCH - R+R     Op. 7065C30 GRAB HANDLE (ONE) LEFT, RIGHT OR CENTRE PASSENGER COMPARTMENT INTERIOR - R.R     Op. 7040E10 FRONT COURTESY LIGHT - R+R     Op. 7065C34 SUN BLIND (ONE), LEFT OR RIGHT - R.R.     Op. 7040H30 FRONT PILLAR TRIM (ONE), LEFT OR RIGHT - R.R.     Op. 7040H38 CENTRE PILLAR UPPER ELEMENT (ONE), LEFT OR RIGHT - R.R     Op. 7050A22 REAR SEAT CUSHION - R+R    Op. 7040L40 FRONT DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R.     Op. 7040H42 REAR PILLAR TRIM (ONE), LEFT OR RIGHT- R.R     Op. 7065C86 CURRENT SOCKET IN LUGGAGE COMPARTMENT - R.R.    Op. 7040G30 BOOT LIGHT BULB HOLDER - R.R.After disconnecting the battery or when a fuse blows or the battery is disconnected, the sliding roof system must be re-initialised as indicated below.- Press the sliding roof button in closed position and hold down until the roof is fully closed. Then, without releasing, wait for the motor to click (metallic noise) (this takes place about 5 seconds after closure).- Release the button, then press again within 5 seconds and hold down throughout an entire sliding roof opening and closure cycle. Release the button once the roof is fully closed.- the initialisation cycle is complete.