199004886 - 2127EC CHECKING THE CLUTCH POSITION POTENTIOMETER (Robotized gearbox)

STEPCHECK TO BE PERFORMEDREMEDIAL ACTION IF THE CHECK IS NOT OK
1Potentiometer power supply checkTurn the key to the MAR positionUse the Examiner voltmeter to connect the positive push rod to pin 79 of the robotized gearbox control unit and the negative to pin 59.    See E7051 ROBOTIZED GEARBOX Check that the voltage is around 5 Volts. Proceed to step 2Replace the robotized gearbox control unit    Op. 2127E10 HYDRAULIC SPEED SELECTION SYSTEM CONTROL UNIT - R.R. and use Examiner to carry out self-learning
2Checking the clutch position signalUse the Examiner voltmeter to connect the positive terminal to pin 52 of the gearbox control unit and the negative terminal to pin 59Turn the key ON and ensure the reading is approximately 2.6 VoltsStart the engine, engage a gear and ensure the reading is around 1.6 Volts (clutch open position)Press the accelerator, take-off and ensure the voltage reading is around 1.8 Volts (clutch position closed)Move on to Step 3
3Check the continuity of the wiringCheck the continuity of the wiring between the potentiometer and the gearbox control unit    See E7051 ROBOTIZED GEARBOX Move on to Step 4Restore the correct wiring continuity
4Potentiometer operation checkDetach the potentiometer from the unit- Connect the probes across pins A and B of the potentiometer and check that the resistance value is 1260 Ohm ±10% at 20°C.- Connect the probes across pins C and B and check that resistance is 2280 Ohm ±10% at 20°C (with slide at rest) and 793 Ohm ±10% at 20°C(with slide at full scale deflection)- Connect the points between pins A and C and check that resistance is 978 Ohm ±10% at 20°C ( with slide at rest) and 2070 Ohm ±10% at 20°C(with slide at full scale deflection)Replace potentiometer    Op. 2127E44 HYDRAULIC SELECTION GEARBOX CLUTCH POSITION SENSOR - R.R. and use Examiner to carry out self-learning. If the check is OKreplace the gearbox control unit    Op. 2127E10 HYDRAULIC SPEED SELECTION SYSTEM CONTROL UNIT - R.R. and use Examiner to carry out self-learning
Robotized gearbox control unit pinout
Potentiometer connector