 | If replacing the service pulley and its built-in phonic wheel, run the following self-learning procedure.- Turn the ignition key ON and start the engine.- If the injection warning light in the instrument panel flashes, this means that the initialisation must be carried out.- With the engine running, wait until it warms up without pressing the accelerator pedal (coolant temperature more than or equal to 77 °C).- With the gear lever in neutral, carry out at least three accelerations until the recommended speed of 6000 rpm is reached; after each acceleration release the accelerator pedal completely and wait for the revs to go down to the idle figure (1000 rpm).- If the injection warning light continues flashing at the end of the operation, this means that the initialization is not completed; continue with the acceleration following the methods described previously until the warning light goes out.- Turn the ignition OFF and wait for at least one minute for the information to be recorded permanently in the memory. |
Removing
(
Refitting
)
