199001649 - 3330C34 BRAKE FLUID RESERVOIR - R + R AND WASH INSIDE - VERSIONS WITH RIGHT HAND DRIVE AND ABS

Removing ( Refitting ) 1. Undo the cap and tighten the tool on the brake-clutch fluid reservoir.

Tool	Description	Function	Validity
2000001400	Plug	Brake/ clutch system vacuum

1. Connect a suitable container to the bleed valve of one front brake caliper.2. Loosen the bleed valve and pump the brake pedal several times to drain the fluid out of the brake fluid reservoir. 1. Disconnect the rapid connectors and remove the hoses from the brake pump. 1. Disconnect the hose for the clutch pump from the reservoir.2. Disconnect the electrical connection for the brake fluid minimum warning light switch.

	Description	Connector
2	Brake fluid level sensor (switch)	See K025 BRAKE FLUID LEVEL SENSOR (SWITCH)

3. Compress the clip (3a) and remove the reservoir (3b) from the mounting bracket. 1. If necessary, compress the clip (1a) and remove the minimum brake fluid warning light switch (1b). Refitting ( Removing ) - Place the brake fluid minimum level warning light switch in its housing and secure it with the retaining clip.- Place the reservoir on the bracket until the fastening clip is fully fitted.- Secure the electrical connection for the brake fluid minimum level warning light switch and close the wiring retaining clip.- Apply pressure to connect the hose for the clutch pump to the reservoir.- Connect the rapid connectors for the hoses to the brake pump.    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR